2 Post Lifts
4 Post Car Lift
2 Post Lift Accessories
4 Post Lift Accessories
Car Scissor Lifts
Mobile Column Lifts
ATV Tire Changers
Motorcycle Tire Changers
Motorcycle Wheel Balancers
Vist Our Showrooms
Requires a minimum of 6" of concrete with 3000 psi.
All lifts come with a step by step instruction manual.
The electric motor for the power unit requires 220 Volt (single phase) 60 Hz (+/- 5%, so 209-231 volts). We recommend using at least a 10 gauge (grounded) wire from the electrical panel. The power unit may or may not have a short pigtail (no plug) that can be wired to either an optional quick disconnect box (mounted on the lift column) or to a male/female plug combination. It is imperative that the lift’s power supply can be disconnected quickly in case of an emergency. Electric motor switches can fail for a variety of reasons. E.G.: abuse….wear…moisture.
If the electric switch would become compromised and the power supply to the lift needed to be disconnected immediately, a quick disconnect box or a male/female electrical plug combination will allow the operator to disconnect the power from the lift.
A 30 amp breaker is required for 220V.
Electrical switches do not last forever and many times do not give an indication of possible failure. Use common sense and make sure that you can disconnect the main power supply to your lift if needed.
Do this before you put a vehicle on your lift.
NO…but YES. Most lifts have only one column that can be used to mount the power unit. This column has the mounting bracket. Make sure that you install that specific column on the side where you want to locate the power unit.
Ceiling height an issue? Learn how to make an Atlas 2-post overhead lift "shorter" than the factory's recommended height.
A checklist of things that you should know and do before you purchase a lift.
Learn how a 2-post above ground lift works.
Find out how you can destroy your 2 post by not using it properly.
View the comparison between 2-post car lifts and 4-post car lifts.
Be the first to Write a Review