Arms Extend Over Runways To Reach All Lift Points

Capacity-4500 lbs.

Commercial Grade

Powder Coat Finish

Air/Hydraulic Pump (Optional)

Truck Adapters Included

The Direct Lift Pro Jack 4500 is an economical rolling hydraulic jack designed to raise the front or rear portion of a vehicle allowing the operator of a four post above ground lift to perform wheel and brake service. Most commercial shops buy two of the hydraulic rolling jacks, so that the entire vehicle can be supported in the air at the same time.

The Direct Lift Pro Jack 4500 is the perfect accessory for the Direct Lift Pro Park 9 Plus. The complete Direct Lift Pro Park 9 Plus four post lift comes with a jack tray. The jack tray has certain limitations that are eliminated by using the Direct Lift Pro Jack 4500. The jack tray (with a small floor jack or jack stands) will support ONLY THOSE LIFTING POINTS of the raised vehicle that are between the runways of the Direct Lift ProPark 9+ four post lift. The Direct Lift Pro Jack 4500 has telescoping arms that can be extended over the runways of the four post lift. The lift pads at the end of these arms can be positioned under the LIFTING POINTS (that are located over the runways of the four post lift) of the vehicle allowing the operator to access many more LIFTING POINTS than just using the jack tray.

The Direct Lift Pro Jack 4500 is equipped with expandable supports which adjust to fit many different brands of four post above ground lifts. These supports have a unique roller system that allows the rolling hydraulic jack to glide easily under the entire length of the vehicle. The large nylon rollers and heavy steel wheels allow the rolling jack to be positioned under the correct lifting points in a matter of seconds.

The Direct Lift Pro Jack 4500 comes standard with a set of peg style truck adapters which increase the lifting height of the lift pads. These truck adapters will allow the Direct Lift Pro Jack 4500 rolling hydraulic jack to raise pick-up trucks that will sit higher off the runways than the average passenger car. The Direct Lift Pro Jack 4500 can be operated with the manual hand pump that is also found on the Direct Lift Pro Jack 3500 or it can be equipped with a commercial air/hydraulic pump that is found on the RJ-7000. The air/hydraulic pump would require a supply of compressed air (air compressor) to work properly. The Direct Lift Pro Jack 4500 rolling hydraulic jack features two solid locking positions that are used when the vehicle is to be suspended above the runways. When the locking positions of the Direct Lift Pro Jack 4500 are engaged, the hydraulic pressure from the lifting cylinder of the Direct Lift 4500 is eliminated. (These locks act much like a pair of jack stands after you lift a vehicle off the ground with a service jack).

View our Shipping Policies