Atlas® PSP-6000 - 6,000 lb. Portable Single Post Lift

Product Code: #XH-PSP-6000
$3,445.00
(1)
$3,445.00
FREIGHT INCLUDED
The Atlas PSP-6000 portable single post lift is the perfect choice for the commercial service shop or the Mr. Homeowner who does not want to tie up a bay space with a permanently mounted above ground lift. This portable vehicle lift allows the operator to walk under the vehicle or move around the vehicle to perform wheel service. When the Atlas PSP-6000 is not in use, it may be rolled out of the way into a corner. The PSP-6000 also has a built-in ramp allowing vehicles to drive over it, further maximizing garage space.



The Portable Single Post Lift rolls easily on a level concrete surface and can be used either inside or outside of your garage. The column fits under a 9 foot (108 inch) ceiling and allows the operator to raise most vehicles high enough to access many parts of the vehicle that would not be accessible with a mid-rise lift.



The Atlas PSP-6000 column is equipped with the chain break mechanism that automatically locks the carriage into place in the unlikely event of a chain failure.





Atlas® PSP-6000 - 6,000 lb. Portable Single Post Lift Specifications
Overall Height102 3/4" (8' 6 3/4")
Max. Lifting Height (Without Truck Adapters)71 2/3" (5' 11 2/3")
Max. Clearance68" (5'8")
Min. Height5"
Overall Maximum DimensionsL: 111 1/2” x W: 96" x H: 102 3/4”
Column Size10 1/2" x 12 1/2"
Distance Between Lifting Pads (Column Side to Offside)39 1/2" - 81"
Distance Between Lifting Pads (Column Side to Column Side)53" - 73"
Distance Between Lifting Pads (Offside Side to Offside)54 1/3" - 91 1/2"
Locking Positions16
Motor110v single phase
Shipping Weight1900 LB
Size:Pages:
Atlas® PSP-6000 Manual1.9 MB33View

Ratings & Reviews

1 review

  • 4 stars
  • 0 reviews
  • 3 stars
  • 0 reviews
  • 2 stars
  • 0 reviews
  • 1 star
  • 0 reviews

Works Good

by -

I have been thinking about buying this lift for at least a year. Was asking my tool dealers if any other shops near me had one so I could check it out. I finally just ordered one. Easy to assemble using a forklift. Very easy to roll around in the shop. Just make sure it is pretty level when lifting the vehicle & position the center of the lift more towards the front of the vehicle. I have lifted a few cars & a couple toyota trucks with it so far and it works great. I also bought four 4 foot jack stands to set the vehicle on and could roll the lift out and pick up another vehicle. I will also be buying 2 short screw jack stands to put under the opposite side of the vehicle to sturdy up the vehicle for doing repairs. No regrets should of bought it sooner and thinking of buying another one.