Atlas® BP10000 Baseplate 10,000 lbs. Capacity 2 Post Lift

Product Code: #ATPK-BP10000X
$2,845.00
(0)
$2,845.00
FREIGHT INCLUDED
In-Store Pick Up Discount Available. Please Call For Details.
The Atlas® BP10000 commercial grade 2 post base plate lift is built for those customers who want to lift heavy vehicles in a low ceiling garage. The Atlas® BP10000 incorporates the popular single point lock release. Columns have a middle welded support gusset that adds extra strength to the oversized columns. If you need to lift a one ton dually or a SMART CAR ® and only have an 11 foot ceiling, then this is lift for your shop.



Greg Smith Equipment Sales has a state of the art above ground lift testing facility in Indianapolis, In. We test our competitors’ lifts and our Atlas® lifts. GET SERIOUS…GET ATLAS®.



We have hydraulic oil in stock!



Greg Smith Equipment stocks a complete inventory of parts for the equipment we sell.

Click here to view photos of our parts department.











Atlas® BP10000 Specifications
Capacity10,000 LB.
Lifting Time

Ask Your Salesperson
Overall Height

111 7/8" (9' 3 7/8")
Overall Floor Width

139 1/8" (11' 7 1/8")
Outside Column to Outside Column134 1/2" (11' 2 1/2")
Maximum Lift Height (Without Adapters)77 3/8" (6' 5 3/8")
Maximum Lift Height (With Adapters)86 3/8" (7' 2 3/8")
Minimum Arm Height4 1/2"
Base Plate Width11"
Inside Column112 1/4" (9' 4 1/4")
Drive Thru103 1/4" (8' 7 1/4")
Column Size9 1/2" x 11"
Column Thickness of Steel6mm
Carriage Thickness of Steel6mm
Arms Thickness of Steel6mm
Cable Diameter.375"
Base Of Lift17 1/2" x 21 1/2" (1' 5 1/2" x 1' 9 1/2")
Motor/Electrical Requirement2.0/3.0 HP 220V +/- 5% (209-231volts) single (1) phase. A 30 amp breaker is required.
Oil Requirement

3-5 Gallons AW32/AW46
Shipping Weight

1,640 LB.


Requires a minimum of 4" of concrete with 3000 psi.

All lifts come with a step by step instruction manual.



Size:Pages:

Atlas® BP10000X Manual2.1 MB35View
Atlas® BP10000 Oil Hose Configuration Addendum190 KB1View
Atlas® BP10000 Cylinder Bleeding Procedure

(Do this immediately after installation)
144 KB2View
Learn how to make the lift 'shorter' than the factory's recommended height
Can I Mount The Power Unit On Any Column?

NO…but YES. Most lifts have only one column that can be used to mount the power unit.
This column has the mounting bracket. Make sure that you install that specific column on the side where you want to locate the power unit.

No reviews available

Be the first to Write a Review